Downloads Support Forums Contact Price List


Split Collar and Magnet Assemblies

These aluminum split collars provide a mounting platform for the magnets that are used to trigger the sensor when monitoring the revolutions of a shaft. They are typically used on rear end yokes or couplers to provide driveshaft RPM. Each collar is approximately .375” wide and houses two magnets which are located 180° apart. Custom size and dual magnet collars are available by special order.

2 Magnet Collars
8 Magnet Collars
Check out our new 8-magnet collars. Perfect for automatic-equipped vehicles, to assist in picking up driveshaft RPM sooner than a conventional 2-magnet collar.
Available in three popular sizes.

Split Collar Assembly
        (Two magnets located 180° apart)
1.375” ID 800-CL-2M-137
1.625” ID 800-CL-2M-162
1.812” ID 800-CL-2M-181
1.875” ID 800-CL-2M-187
2.125” ID 800-CL-2M-212
2.187” ID 800-CL-2M-218
3.187” ID 800-CL-2M-318
3.250” ID 800-CL-2M-325
3.500” ID 800-CL-2M-350
Dual Split Collar Assembly
         (Two pairs of magnets located 180° apart)
1.625” ID 800-CL-D2M-162
1.700” ID 800-CL-D2M-170
1.750” ID 800-CL-D2M-175
2.000” ID 800-CL-D2M-200
2.187” ID 800-CL-D2M-218
Magnet Only, .250” dia. x .200” long 800-MG-SM-.25

Racepak LLC
30402 Esperanza, Rancho Santa Margarita, California 92688
Sales & Tech Support: 888-429-4709 • Main: 949-709-5555 • Fax: (949) 709-5556

All text, descriptions, software, images, and other content of this website are the property of Racepak LLC. All rights reserved.
Privacy policy

Click here to add this page to your favorites