Downloads Support Forums Contact Price List
 


 
Check out our new
video section
tutorial_footer
PRO Series Cables


Cables for the Pro series recorders, although sometimes similar in appearance to other cables, are tailored specifically for their individual uses. It is important to use the proper cable for each application.

Engine RPM PN#
Fiber Optic Cable (Order in even one foot increments)
(Connects spark pickup module to recorder)
800-OP-CABLE


RPM Module PN#
Data Recorder to RPM Module
(Available in various lengths from 8 to 180 inches)
800-CA-13H-(specify length)
Clutch RPM Sensor to RPM Module, 3 Pin (Early) 800-CA-3PM-(specify length)
Clutch RPM Sensor to RPM Module, 3 Pin (Late) 800-CA-TDC-(specify length)
Drive Shaft RPM Sensor to RPM Module, 2 Pin 800-CA-2PM-(specify length)
Ring Gear RPM Sensor to RPM Module, 3 Pin 800-CA-3PM-(specify length)
Front Wheel Sensor to RPM Module, 3 Pin 800-CA-3PM-(specify length)
Flow Meter to RPM Module 800-CA-FM-(specify length)
Power (On/Off) Switch to RPM Module 800-CA-PWR-(specify length)
(Early recorders are those manufactured before 2001. Late is 2001 and newer.
2 pin and 3 pin denotes the type of connector that is attached to the sensor.)


Pro Analog Transducer Box PN#
Recorder to Transducer Box, or Box to Box
(Available in various lengths from 8 to 180 inches)
800-CA-13H-(specify length)
Low Temp Thermocouple (0-500°) to Transducer
(For cable lengths less than 36 inches)
800-CA-TCEXT-XX (specify length)
Low Temp Thermocouple (0-500°) to Transducer
(For cable lengths greater than 36 inches)
800-CA-TCEXT-XL (specify length)
Travel/Position Sensor (Linear) to Transducer 800-CA-3PM (specify length)
G-Meter to Transducer 800-CA-3PM (specify length)
Ride Height Sensor to Transducer 800-CA-3PM (specify length)


Timing Module PN#
PRO II Recorder to Timing Module
(Available in various lengths from 8 to 180 inches)
800-CA-13H-(specify length)
TDC Sensor to Timing Module 800-CA-TDC-(specify length)
MSD Delay Box to Timing Module 800-CA-DBX-(specify length)
Mag Phasing, Magneto to Timing Module 800-CA-MAG-(specify length)


Exhaust Gas Temperature
(Measured from recorder to end of longest leg)
PN#
Recorder to EGT Junction Boxes, Standard 800-CA-EGT-(specify length)
Recorder to EGT Junction Boxes, Reversed 800-CA-EGTR-(specify length)
(Available in 8', 10', 11', 12', 13', 14', 15' lengths)


Pro Dash PN#
Pro Dash to PRO II Recorder
 (Connects spark pickup module to recorder)
110-CA-DASH-(specify length)
 
Click here to add this page to your favorites
 
30402 Esperanza, Rancho Santa Margarita, California 92688 Phone: 949-709-5555 Fax (949) 709-5556
All text, descriptions, software, images, and other content of this website are the property of Competition Systems, Incorporated. All rights reserved.
Privacy policy