Filter Product
|
Sensors
The following RPM sensors are those commonly used in conjunction with the RPM Module.
800-SS-PRO-5 |
Driveshaft RPM
on V300, V500 and all Pro Series recorders |
|
800-SS-PRO-5 |
Driveshaft RPM
on V300SD |
|
800-SS-MSC-5 |
Clutch RPM, Zero Crossing
on V300, V300SD, V500, Pro 1B and Pro II |
|
800-SS-ZX-3 |
Ring Gear RPM
on Pro 1B and Pro II |
|
800-SS-MSC-3 |
| TDC, Zero Crossing (MSD type) |
|
800-SS-TDC-3 |
Each of the conventional-style data recorders has dedicated terminals for the input of the engine RPM signals. This signal is sourced with a combination of a primary spark sensor and a fiber optic cable. The primary spark sensor picks up the spark pulse between the magneto and the coil/control box, or at the tach terminal on an electronic ignition control box. A fiber optic cable is then used to relay the signal from the spark pickup module to the recorder. Battery and magneto ignition systems require different spark pickup modules that are not interchangeable.
| V300 & V500 |
Engine RPM Pickup, Magneto Ignition |
280-CA-MAGPU |
|
Engine RPM Pickup, Battery Ignition |
280-CA-HARNMSD |
| V300SD |
Engine RPM Pickup, Magneto Ignition |
280-CA-MAGPU3 |
|
Engine RPM Pickup, Battery Ignition |
280-CA-HARNMSD3 |
| |
|
|
Pro Systems
 |
Engine RPM Pickup, Magneto Ignition |
800-OP-MAG |
| |
Cable, Fiber Optic (specify length)
- for use with Magneto Pickup 800-OP-MAG |
800-OP-CABLE
|
 |
Engine RPM Pickup, Battery Ignition |
800-OP-MSD |
|
