V-NET CABLES & ACCESSORIES

V-Net Cables

V-Net cables are the links that tie a V-Net system together. When the modules for the individual V-Net sensors cannot be connected directly to each other, or the sensors are located a long distance from the data recorder, the gap must be bridged using these special cables. All V-Net cables can be identified by their blue 5 pin connector on each end. Do not attempt to use any other type of cable for this purpose. Standard length cables are shown below. Custom lengths can be made on special order.

Cable, 6” 280-CA-VM-6

Cable, 12” 280-CA-VM-12

Cable, 18” 280-CA-VM-18

Cable, 24” 280-CA-VM-24

Cable, 36” 280-CA-VM-36

Cable, 48” 280-CA-VM-48

Cable, 60” 280-CA-VM-60

Cable, 72” 280-CA-VM-72

Cable, 84” 280-CA-VM-84

Cable, 96” 280-CA-VM-96

Cable, 108” 280-CA-VM-108

Cable, 120” 280-CA-VM-120

Cable, 144” 280-CA-VM-144

Cable, 168” 280-CA-VM-168

Cable, 192” 280-CA-VM-192

Cable, 216” 280-CA-VM-216

Tee Connector Module

All V-Net data recorders are shipped with a 9” long cable-type Tee module (center item in photo at left). The purpose of the Tee Connector Module is to provide a means of either splitting the V-Net into two separate branches, or to facilitate a position for one of the terminator caps. Replacement Tee Connector Modules are available by ordering the part number shown below.

V-Net Tee Module 280-CA-VM-TEE

Terminator Caps

Terminator caps are a necessary part of the V-Net system. The longest leg of the V-Net cable, as well as the other leg branching off from the Tee module, must end with a terminator cap for the system to function properly. All V-Net recorders are shipped with one male and one female terminator cap. In order to avoid confusion with dust caps used with Interface modules, these 5 pin terminator caps are color coded blue just like all other components that connect to the V-Net system.

Terminator Cap, Male, 5 Pin 280-CA-VM-TCAPM

Terminator Cap, Female, 5 Pin 280-CA-VM-TCAPF