RPM MODULE

CONVENTIONAL RECORDERS

 

 

 

In order to eliminate the mass of wiring that would be required to route the wires from all the digital / RPM sensors that could be connected to the Pro Series data recorders, Racepak has developed this RPM Module. It collects the input from the various sensors and transfers them to the recorder via a single cable. Additionally it provides an LED indicator for each sensor that verifies channel activity. RPM Modules can collect input from clutch, drive shaft, and ring gear sensors, multiple flow meters, as well as the power switch. Consult with the Racepak Technical Department on specific uses.

 

Note: the purchase of an RPM Module or sensors alone does not insure their ability to record a sensor’s activity. The data recorder must have an available digital channel properly configured for each sensor’s use.

 

RPM Module   110-MD-INPA

                                                                     

 

 

 

Sensors

 

The following RPM sensors are those commonly used in conjunction with the RPM Module.

 

Sensor, TDC, Zero Crossing (MSD type) 800-SS-TDC-3
Sensor, RPM, Zero Crossing 800-SS-ZX-3
Sensor, Front Wheel RPM/Speed, Hall Effect, 3 Pin 800-SS-HEM-3
Sensor, Ring Gear, Hall Effect, 3 Pin 800-SS-MSC-3
Sensor, RPM, Magnetic Contact, 2 Pin 800-SS-PRO-5

                                                  

                                

Cables

 

The following selections of cables are those commonly used with the RPM Module.

 

Cable, Module to Recorder, 13 Pin 800-CA-13H-(specify length)
Cable, Module to Flow Meter 800-CA-FM-(specify length)
Cable, Module to RPM Sensor, 2 Pin  800-CA-2PM-(specify length)
Cable, Module to Powered RPM Sensor, 3 Pin 800-CA-3PM-(specify length)
Cable, Module to Zero Crossing RPM Sensor 800-CA-3PF-(specify length)
(Used with TDC and clutch sensors)  
On/Off Switch Assembly   800-CA-PWR-(specify length)