TRANSDUCERS & SIGNAL CONDITIONING MODULES,

MODULAR PLUG-IN STYLE

For your data recorder to be able to monitor an analog channel it must receive a signal that it can recognize. The modules shown here convert the analog parameters to a standard 0-5 volt signal required by the  

recorder. The transducer modules (combination sensor and signal conditioning modules) provide direct

connection to the measured parameter, such as fuel or oil pressure. The signal conditioning modules allow the connection of remote sensors, such as thermocouples or position sensors, to the data recorder.

 

The following transducers and signal conditioning modules are the modular plug-in style for use with our Pro Analog Transducer Box. They are also the type that is mounted directly into the sidewall of Pro 1-A recorders.

 

Pressure Transducer     810-MD-PT-(specify psi)
Used to convert the signal from parameters such as fuel, oil, or nitrous pressure.  
Available in psi ratings of: 1.5 / 15 / 30 / 60 / 100 / 200 / 300 / 400 / 500 / 600 / 1000 / 1500  

 

Vacuum Transducer, 0-30 In. hg    810-MD-VAC
Typically used when monitoring manifold or pan vacuum.  

 

Thermocouple Amplifier Module, 0-500°F 810-MD-TC-500
Used on low temperature applications such as water, oil, cylinder head. Not for use with EGT’s.  
Cable Only, Thermocouple Sensor to Module 800-CA-TC500-(specify length)

 

Travel / Position Module, Rotary  810-MD-RPOS
Travel / Position Module, Linear    810-MD-LIN
Cable Only, Sensor to Module, Linear or Rotary   800-CA-POS-(specify length)

                        

G-meter Interface Module 810-MD-GM
Used with G-Meters that are not internally mounted in a data recorder.  
Cable Only, G-meter to Module 800-CA-GM3-(specify length)

                                                                                     

                          

Air / Fuel Interface Module 810-MD-A/F
Used to interface signals from a NGK air/fuel sensor.  
Cable Only, NGK Sensor to Module 800-CA-AF-(specify length)

 

Strain Gauge Amplifier Module  810-MD-SG
Offered as a method of integrating and amplifying the signal from a customer’s strain gauge.  
Consult with Racepak for details of integrating with your strain gauge.  

 

0-5 Volt Input Module, Outputs 5 volts to power a sensor    810-MD-0-5-5V
0-5 Volt Input Module, Outputs 12 volts to power a sensor 810-MD-0-5
Receives 0-5 volt input from powered sensor, while outputting 5 or 12 volts to power the sensor.  
Cable Only, Sensor to either Module 800-CA-3PM-(specify length)