These aluminum split collars provide a mounting platform for the magnets that are used to trigger the sensor when monitoring the revolutions of a shaft. They are typically used on rear end yokes or couplers to provide driveshaft RPM. Each collar is approximately .375” wide and houses two magnets which are located 180° apart. Custom size and dual magnet collars are available by special order.

Split Collar Assembly         (Two magnets located 180° apart)
1.375” ID	800-CL-2M-137
1.625” ID	800-CL-2M-162
1.812” ID	800-CL-2M-181
1.875” ID	800-CL-2M-187
2.125” ID	800-CL-2M-212
2.187” ID	800-CL-2M-218
3.187” ID	800-CL-2M-318
3.250” ID	800-CL-2M-325
3.500” ID	800-CL-2M-350
Dual Split Collar Assembly          (Two pairs of magnets located 180° apart)
1.625” ID	800-CL-D2M-162
1.700” ID	800-CL-D2M-170
1.750” ID	800-CL-D2M-175
1.875” ID	800-CL-D2M-187
2.000” ID	800-CL-D2M-200
2.187” ID	800-CL-D2M-218
Magnet Only, .250” dia. x .200” long	800-MG-SM-.25