Racepak.com

When the problem started was we noticed that 1 of our runs didnt get recorded, we didnt do anything about it since we thought the guy in our crew didnt push the record button good enough to make it start recording, we ran another pass right away and it worked like nothing have happend.

Then now at another race it just stopped randomly workingn again, we didnt have any tire shake or anything wierd like that, so we tried to get it to work again but now we noticed that when we pressed the record button it was flashing red as it should then it flashed green back n fourth which we aint seen before, desperate as we was we put the memory card in the computer cleaning out all the old files, then we went to start it up and now its just showing a yellow light all the time, dont even react when we press the button, what have happend?

off topic, we recently bought a new computer and we want add the manifold temp to the racepak program but we cant manage to get it to work, what should we do?

Sir,

The flashing red then a green is normal. This means that its in the process of recording a file. The yellow mean the logger is not reading the card. It may have been put in upside down and bent one of the pins in the slot causing it not to read the card and now its in error mode. Try to move the card around a bit and see what you can get. If not it may have to come back here for us to repair it.

As for the manifold temp issue, what is not working? Did you read it into the config to sync it up to the config file? Are you getting some sort of error??? We would need a little more info to look into this issue.