Racepak.com • View topic - New Variables Added

View unanswered posts | View active topics

Board index » Software

All times are UTC

New Variables Added - Error Message Upon Import

Moderators: tim@racepak, todd@racepak, admin

Page 1 of 1

[ 3 posts ]

Print view

Previous topic | Next topic

Author

Message

velohead

Post subject: New Variables Added - Error Message Upon Import

Posted: Wed Jul 04, 2012 4:44 am

Joined: Mon Feb 14, 2011 3:56 am
Posts: 17
Location: Brisbane

Hi All,

I have a IQ3 which both displays and records (to SD card) engine variables etc.
I have added 2 new variables being.... oil_temp_1 and oil_temp_2

The IQ3 displays these variable ok, And I presume will record them too.

When I open the .DDF file (with the DataLink Software), then I get the following 2 messages....

So, what do I have to do in order to see these variables in the DataLink Software.
Thanks.

Top

widemr

Post subject: Re: New Variables Added - Error Message Upon Import

Posted: Wed Jul 04, 2012 5:00 am

Joined: Fri Nov 04, 2011 10:32 pm
Posts: 48
Location: Melbourne, Australia

Have you done a 'read config' in datalink recently? Do the channels appear in datalink in your config file?

Top

velohead

Post subject: Re: New Variables Added - Error Message Upon Import

Posted: Wed Jul 04, 2012 5:47 am

Joined: Mon Feb 14, 2011 3:56 am
Posts: 17
Location: Brisbane

I'll try to do a 'read config' tonight.

It is a pain as there is no laptop, and the old PC has to be moved into the garage, and being an old PC, it takes half hour to load up.

The old PC runs XP.
The new PC runs Windows 7, but still using the old PC for Racepak.

Top

Page 1 of 1

[ 3 posts ]

Board index » Software

All times are UTC

Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum