|
For your data recorder to be able to monitor an analog channel it must receive a signal that it can recognize. The modules shown here convert the analog parameters to a standard 0-5 volt signal required by the recorder. The transducer modules (combination sensor and signal conditioning modules) provide direct connection to the measured parameter, such as fuel or oil pressure. The signal conditioning modules allow the connection of remote sensors, such as thermocouples or position sensors, to the data recorder.
The following transducers and signal conditioning modules are the modular plug-in style for use with our Pro Analog Transducer Box. They are also the type that is mounted directly into the sidewall of Pro 1A recorders.
| Pressure Transducer    |
810-MD-PT-(specify psi) |
| Used to convert the signal from parameters such as fuel, oil, or nitrous pressure. |
|
| Available in psi ratings of: 1.5 / 15 / 30 / 60 / 100 / 200 / 300 / 400 / 500 / 600 / 1000 / 1500 |
|
| Vacuum Transducer, 0-30 In. hg   |
810-MD-VAC |
| Typically used when monitoring manifold or pan vacuum. |
|
| Thermocouple Amplifier Module, 0-500°F |
810-MD-TC-500 |
| Used on low temperature applications such as water, oil, cylinder head. Not for use with EGT’s. |
|
| Cable Only, Thermocouple Sensor to Module |
800-CA-TC500-(specify length) |
| Travel / Position Module, Rotary |
810-MD-RPOS |
| Travel / Position Module, Linear   |
810-MD-LIN |
| Cable Only, Sensor to Module, Linear or Rotary  |
800-CA-POS-(specify length) |
| G-meter Interface Module |
810-MD-GM |
| Used with G-Meters that are not internally mounted in a data recorder. |
|
| Cable Only, G-meter to Module |
800-CA-GM3-(specify length) |
| Air / Fuel Interface Module |
810-MD-A/F |
| Used to interface signals from a NGK air/fuel sensor. |
|
| Cable Only, NGK Sensor to Module |
800-CA-AF-(specify length) |
| Strain Gauge Amplifier Module |
810-MD-SG |
| Offered as a method of integrating and amplifying the signal from a customer’s strain gauge. |
|
| Consult with Racepak for details of integrating with your strain gauge. |
|
| 0-5 Volt Input Module, Outputs 5 volts to power a sensor   |
810-MD-0-5-5V |
| 0-5 Volt Input Module, Outputs 12 volts to power a sensor |
810-MD-0-5 |
| Receives 0-5 volt input from powered sensor, while outputting 5 or 12 volts to power the sensor. |
|
| Cable Only, Sensor to either Module |
800-CA-3PM-(specify length) |
|
